The Weller WTCPT soldering station is tranformer powered and is complete with a lightweight, heat insulated, low voltage, temperature controlled soldering iron. The special Weller® "closed loop" method of controlling maximum tip temperature is employed, thereby protecting temperature sensitive components. The soldering iron features a stainless steel, plug in heating element construction, a non-burning silicone rubber cord, and a large selection of tip in sizes from 1/64" diameter to 15/64" diameter with a choice of tip temperatures of 600°F, 700°F and 800°F. The soldering iron is normally provided with a PTA7 1/16" screwdriver 700°F tip.
The station features a housing of an impact resistant polycarbonate plastic for durability and protection against accidental damage, a quick disconnect lug for the soldering iron, a lighted on-off switch, and a flexible 3 wire power cord.
The plastic soldering iron holder can be attached to either side of the tranformer case, or separated as shown. The iron holder incorporates a water reservoir with wick to kep the tip wiping sponge moist.
The station housing and hand piece are grounded with a separate conductor that terminates at the third pin on the power cord. Weller® WTCPT units are UL listed.