Training employees to remove/replace Surface Mount Components is expensive if you have to draw from good inventory. This practice board provides a range of component pads intended to be used by new employees until they are competent with your desoldering/soldering equipment.
Components themselves are not supplied, and it is suggested that you use defectives from your inventory or low cost components.
Both sides of the PC board are identical and each side contains the following footprints:
- 1 PLCC 68 pin
- 1 PLCC 44 pin
- 1 PQFP 68 pin Bumper pack
- 8 SOT-23
- 2 PLCC 28 pin
- 4 PLCC 20 pin
- 1 PLCC 24 pin
- 3 PLCC 18 pin
- 2 SOIC 14 pin
- Assortment of SOT-143, 3216, SOT89 and 0805 patterns.
Employees can lear the job well een if your exact patterns are not on this training board.